PHjhonmarkhallare0
Grasshopper
disassembly
Detach the power cable:
The disassembling of the computer system starts with externally connected device detachment.
Remove the Cover:
The standard way of removing tower cases used to be to undo the screws on the back of the case, slide the cover back about an inch and lift it off.
Remove the adapter cards:
Make sure if the card has any cables or wires that might be attached and decide if it would be easier to remove them before or after you remove the card.
Remove the drives:
Removing drives is easier. There can be possibly three types of drives present in your computer system, Hard disk drive, CD/DVD/Blue-ray drives, floppy disk drives
Remove the memory module:
Memory modules are mounted on the motherboard as the chips that can be damaged by manual force if applied improperly.
. SIMM - gently push back the metal tabs while holding the SIMM chips in the socket. Tilt the SIMM chip away from the tabs until a 45% angle. It will now lift out of the socket. Put SIMM in a safe place.
.DIMM- There are plastic tabs on the end of the DIMM sockets. Press the tabs down and away from the socket. The DIMM will lift slightly. Now grab it by the edges and place it safely. Do not let the chips get dust at all.
Remove the power supply:
The power supply is attached into tower cabinet at the top back end of the tower.
Remove the motherboard:
Before removing all the connectors from the motherboard, make sure u memorize the connectors for assembling the computer if required, as that may require connecting the connectors at its place.
Detach the power cable:
The disassembling of the computer system starts with externally connected device detachment.
Remove the Cover:
The standard way of removing tower cases used to be to undo the screws on the back of the case, slide the cover back about an inch and lift it off.
Remove the adapter cards:
Make sure if the card has any cables or wires that might be attached and decide if it would be easier to remove them before or after you remove the card.
Remove the drives:
Removing drives is easier. There can be possibly three types of drives present in your computer system, Hard disk drive, CD/DVD/Blue-ray drives, floppy disk drives
Remove the memory module:
Memory modules are mounted on the motherboard as the chips that can be damaged by manual force if applied improperly.
. SIMM - gently push back the metal tabs while holding the SIMM chips in the socket. Tilt the SIMM chip away from the tabs until a 45% angle. It will now lift out of the socket. Put SIMM in a safe place.
.DIMM- There are plastic tabs on the end of the DIMM sockets. Press the tabs down and away from the socket. The DIMM will lift slightly. Now grab it by the edges and place it safely. Do not let the chips get dust at all.
Remove the power supply:
The power supply is attached into tower cabinet at the top back end of the tower.
Remove the motherboard:
Before removing all the connectors from the motherboard, make sure u memorize the connectors for assembling the computer if required, as that may require connecting the connectors at its place.