🔒 Closed Extend cable of 18dbi mimo antenna

[ken_05]

Hi,

Newbie lng po. Just bought 18dbi mimo antenna w 15 meters cable. Trying to install kaya lng kulang ung haba ng cable. Meron po bang way para maextend ung cable?

Pahelp nmn po kung pano cya maeextend mga 50m pa. what po tawag dun s cable ska san nakakabuy? Or if may iba pa suggestions.

Thanks po in advance

 

[Matulis_2]

check this site...
this may help you...

You do not have permission to view the full content of this post. Log in or register now.

 

[ken_05]

check this site...
this may help you...

You do not have permission to view the full content of this post. Log in or register now.

Salamat po boss s link. nsa 1710-2690 MHz nklgay n frequency ng antenna. Hnggng 30m lng pla ped pra full bar.

Kkasad nmn.

 

[ken_05]

Nilabas ko nlng s may bintana, nag-4 bars na cya. Ok ndin to khit di nag-5 bars. Salamat po!

 

[ken_05]

Thanks a lot. You save me from unncessary expenses

 

[Matulis_2]

Thanks a lot. You save me from unncessary expenses

welcome bro

 

[Mrdubiman]

check this site...
this may help you...

You do not have permission to view the full content of this post. Log in or register now.

Sir good afternoon. May alam po ba kayo kung san nakakabili ng extension cable ng 18dbi antenna? need ko pa kase itaas pa ng kunti yung sakin. Bitin yung 15m. salamat in advance.

 

[Matulis_2]

Sir good afternoon. May alam po ba kayo kung san nakakabili ng extension cable ng 18dbi antenna? need ko pa kase itaas pa ng kunti yung sakin. Bitin yung 15m. salamat in advance.

Try mo sa cdr-king

Note:
Most antennas are typically available as complete kits, which include one or two antennas, 5 to 10 metres of RG-58 coaxial cable and the connectors. Some kits also include a wall mount bracket.

Try to keep the cable run as short as possible, preferably within 10 metres. With short cable runs, the signal to noise ratio remains mostly consistent all the way to the radio hardware. With long cable runs, some otherwise discernible signals will fall below the noise floor of the radio hardware. Similarly, unwanted signals that penetrate the cable shielding will interfere with the weakened signal towards the device end.

 

[JewelHanda]

Hi....I believe you'll break the MIMO feature of your router by separating the antennas like that. Not to mention you'll have a serious signal loss problem if you are extending the antenna by more than a few feet without some pretty hardcore cabling

 

[Mackits]

Diko maintindihan po.

 

[I am nobody]

Thanks a lot. You save me from unncessary expenses

anu yung nasa link? down na kasi